Sub-Transmission Disassembly - Honda MUV700 big red Service Manual

SUB-TRANSMISSION/GEARSHIFT LINKAGE
Coat a new O'ring with engine oit and install it onto
the oil filler pipe.
Install the filler pipe with the two bolts.
Connect the oil filler hose onto the pipe.
Install the EOT sensor with a new sealing washer
and tighten it.
TORQUE: 12 N ·m (1.2 kgf-m , 9 Ibf.ft)
Install the reduction gears and alternator cover
(page 11 -8).
Connect the gear position switch 3P (black) connec-
~~~~~'::::::~~~~!':'::~:::~~~
tor.
Connect the front propel ler shaft (page 8·10).
Install the following:
- rear propeller shaft (page 8-12)
- starter motor (page 23-11)
- exhaust system (page 3·26)
SUB-TRANSMISSION
DISASSEMBLY
Remove the rear crankcase cover (page 12-5).
Remove the following:
washer
idle gear (25T)
idle gear (13T)
washer
- gear shaft
3P CONNECTOR
12-9