Honda MUV700 big red Service Manual page 538

REAR DRIVING MECHANISM
Sel the drive mode selector lever to the 2WD posi-
tion (differential lock free position).
Operate the differential lock arm to the front side to
set it to the lock free position.
Install the differential lock cable into the clip and the
cable holder by aligning the flat surfaces, and con-
nect the cable to the lock arm.
Install the washer and a new cotter pin.
Make sure that tne
Screw the cable nuts together gradually (to move
drive mode selector
both nuts to the cable holder side ) by your hands so
/ever
15
2WD
that the cable does not forced until they are touched
position and the
to the cable holder.
dlffel8ntlilllock arm
Tighten the cable nut while holding the other nut.
IS
lock
free (front)
TORQUE: 26 N·m (2.7 kg f·m. 20 Ib'·tt)
POSition.
20-34
InSl all the VS sensor (page 6-53).
Install the sensor wire band onto the cable holder.
Connect the breather hose.
Install the damper stay and tighten the two bolts.
Install the following:
- cargo bed damper (page 3-16)
- drive shafts (page 20-11 )
Fill the gear case with the recommended oil (page 4-
17) .
Adjust the selector cable (page 19-44).