Honda MUV700 big red Service Manual page 537

Coat a new C·ring with molybdenum disulfide
grease and install it into groove in the propeller
shaft groove.
Install the propeller shaft into the universal joint
until it is fully seated.
Apply molybdenum disulfide grease to the splines
of the propeller shaft.
Install the joint spring into the propeller shaft firmly.
Place the gear case assembly into the frame.
Connect the propeller shaft, aligning the splines
properly while compressing the joint spring, then
align the bolt holes and install the mounting bolts
from the right si de.
Install new mounting nuts and tighten them.
TORQUE: 54 N·m (5.5 kgf·m , 40 Ibf.ft)
REAR DRIVING MECHANISM
20-33