Honda MUV700 big red Service Manual page 407

Make sure the snap
ring is firmly seated
in the groove .
Install the snap ring into the groove in the housing
with the chamfered side facing down.
Wrap vinyl tape around the pinion splines and
groove, and coat it with grease to avoid damaging
the dust seal lip.
Apply grease to a new dust seal lips. Install the dust
seal with the flat side facing up until it is fuJly
seated.
TOOLS:
Driver, 22 mm 1.0.
Base collar
Remove the tape.
07746-0020100
07GAJ-PG20120
Pack 2 - 5 9 of grease in between the dust seal and
cover (shadowed area) .
Be sure the dust
Install the dust cover and fit it into the pinion
cover does not
groove.
comact the gear
box housing
STEERING SYSTEM
rum
DRIVER
W.2 -
0.5 9)
\
~
SNAP RING
SPLINES
~
• ...$iiiiiW
12-59)
COLLAR
DUST SEAL _ , .... "
GROOVE
DUST
COVER
Apply grease to the sliding surface (rack side) of the
~========~::=~~=======;
ra ck guide.
Apply sealant to the threads of the ra ck guide screw.
Install the following:
- rack guide
- cone washer (with the concave side facing out)
- pressu re spring
- rack guide screw
- lock nut
Perform the rack guide adjustment (page 4-26).
Check the rack and pinion for smooth movement.
WASHER
16-17