Front Final Gear Assembly - Honda MUV700 big red Service Manual

FRONT DRIVING MECHANISM
Place the driver, attachment and pilot on the top of
the bearing and tape the driver to the compressor.
TOOLS :
Driver
Attachme nt, 22
x
24 mm
Pilot, 15 mm
07949·3710001
07746·0010800
07746·0040300
Place the bearing and tool assembly into a freezer
for at least 30 minutes.
Using a heat gun, heat the gear case to
80~C
(176
c
F).
Remove the bearing and tool assembly from the
freezer and drive the bearing into the gear case
using the special tools.
Only strike the driver once. If you strike it more than
once, the stopper ring may slip out of the groove. If
this happens, remove the ring and bearing, and
install a new ring.
Make sure that the stopper ring is securely set in the
groove of the gear case.
FRONT FINAL GEAR ASSEMBLY
GEAR CASE
COVER
SPRING
PLUG
SEALING
WASHER
CABLE
STOPPER ______ /
SPRING
c
STEEL BAll
SEALING
WASHER DIFFERENTIAL
\~~KSWITCH
---"y-
HALF SHAFT
DOWEL PINS
DIFFERENTIAL lOCK
CLUTCH HOUSING
LOCK
SLEEVE
PINS
O-RING
FINAL CLUTCH
HOUSING
WASHER
DIFFERENTIAL
SLEEVE
PINION BEARING (6206)
19-36
DIFFERENTIAL
BEARING (6009)
RING GEAR
PINION JOINT NEEDLE
BEARING (12
x
18
x
12)
,
PIN ION NEEDLE
BEARING (15 25 x 16)
I I
GEAR
RING
GEAR CASE
OIL SEAL
LOCK
NUT
PINION
SHIM