Honda MUV700 big red Service Manual page 351

Blow the oil orifice with compressed air to clean the
passage.
Coat new O-rings with engine oil and install them
into the orifice grooves.
Install the oil orifice with the small end facing out.
Install the two dowel pins.
Make sure the
Install the following front crankcase cover.
mating surfaces
Install the fourteen bolts and tighten them in a criss-
touch evenly. There
cross pattern in several steps.
should be no
clearance between
rfle cover and
crankcase.
Coat a new O-ring with engi ne oil and install it onto
the flange of the feed pipe B.
Apply engine oil to the outer surface of pipe B.
Align the flange
Carefully insert feed pipe 8 wh i le turning it slowly to
tabs with the
avoid damaging the oil seal in the cra nkcase.
grooves
In
the
cover.
DRIVETRAIN SYSTEM
14-41