Honda MUV700 big red Service Manual page 224

ENGINE REMOVAL/INSTALLATION
The mountmg bolts
are ins railed from
the leff side
8-10
Install the mounting rubbers onto the upper mount-
ing bushing in the hanger bracket with the large 1.0.
side facing in.
Install the hanger bracket with the 10-mm hanger
bolt (from the front side) and nut.
Install the two 8-mm hanger bolts.
After installing all the mounting fasteners and seat
them, tighten the fasteners in ord er as follows:
- left and right lower engine hanger nuts
TORQUE: 54 N'm 15.5 kgf·m. 40 Ibf.ft)
- left and r ight lower hanger bracket bolts
TORQUE: 26 N'm 12.1 kgf.m, 20 Ibf.ft)
- frame side upper engine hanger bolt
TORQUE: 54 N-m (5.5 kgf-m, 40 Ibf.ft)
- engine side upper engine hanger bolts
TORQUE: 32 N'm (3.2 kgf·m, 24 Ibf.ft)
Coat a new O-ring with molybdenum disulfide
grease and install it i nto the output shaft groove.
Apply molybdenum disulfide grease to the propeller
shaft joint splines.
Move the gear case assembly forward for maximum
clearance between the shaft joi nt and output shaft.
Engage the shaft joint over the output shaft and
move the gear case assembly rearward.
Align the upper mounting bolt holes in the gear
case and frame, then install the mounting bolt (12
mm ) and a new mounting nut.
Install the mounting bracket with the two bolts (10
mm).
Install the upper mounting bolt (12 mm) and a new
mounting nut.
Tighten the all the gear case mounting fasteners.
TORQUE: 12 mm: 54 N·m (5.5 kgf·m, 40 Ibf.ft)
BRACKET
BOLTS