Honda MUV700 big red Service Manual page 411

The mountmg boils
are ins/ailed from
tneleft
Side
Al ign the upper mounting bolt holes in the gear
case and frame, then install the mounting bolt (12
mm) and a new mounting nut.
Install the mounting bracket with the two bolts (10
mm).
Install the upper mounting bolt (12 mm) and a new
mounting nut.
Tighten the all the gear case mounting fasteners.
TORQUE : 12 mm : 54 N' m (5.5 kgf·m , 40 Ibf·ft)
Install the holder bracket and cover base with the
two bolts, and tighten them.
TORQUE : 10 N·m (1.0 kgf·m. 7 Ibf.ft)
STEERING SYSTEM
10mm
BOLTS
Sel the drive mode selector lever to the 2WD posi·
r-------~----------__,
tion.
Install the spring onto the 2WD/4WDselector cable.
Insert the cable into the cable holder and connect it
to the clutch arm with the joint pin and adjusting
nut.
Set the groove in the cable grommet onto the cover
base end properly.
Install the retaining plate onto the cable with the
concave facing the cable holder to secure the cable.
Adjust the selector cable (page 19-46).
16-21