Front Wheel Hub And Knuckle Inspection; Brake Disc Replacement - Honda MUV700 big red Service Manual

FRONT WHEEL/SUSPENSION
To prevent the tool from dropping, tie the strap on a
neighboring solid part such as the frame pipe, shock
absorber, etc. before operation.
NOTE :
• Do not tie the strap on the brake hose, brake
pipe, rubber boot, and other parts that can be
damaged easily.
Once the tool is in place, turn the adjusting bolt as
~======;';~~~~B;O~LT ; =====l
necessary to make the jaws parallel.
I
Do
not ge r grease
on the brake disc or
sloppmg power will
be
reduced.
15-12
Then hand-tighten the pressu re bolt and recheck the
jaws to make sure they are stil l parallel.
Tighten the pressure bolt with a wrench until the
ball joint stud pops loose.
Remove the ball joint nuts and the knuckle.
INSPECTION
Remove the dust seals from the knuckle.
Turn the inner race of the bearing in the knuckle
with your finger. The bearings should turn smoothly
and quietly. Also check that the bearing outer race
fits tightly knuckle.
Inspect the knuckle for damage or cracks.
Inspect the ball joint boot for tears or other damage
by moving the ball joint stud.
It should move freely and smoothly.
BRAKE DISC REPLACEMENT
Remove the four bolts and brake disc from the
wheel hub.
Install a new brake disc with the stamp mark facing
the hub.
Instan new disc bolts and tigh ten them.
TORQUE:
42
N·m (4.3 kgf·m.
31
Ibf.ftl
ADJUSTING BOLT
BOLTS
:11