Honda MUV700 big red Service Manual page 359

If
either sup port
InstaH the speciallools onto th e shih clutc h.
block end
IS
set
over an area of the
TOOLS:
(el8mer which
IS
unsupported by the
rerum sprmg. the
retamer may
be
d8tmJged.
Clutch compressor attachment 07LAE-PX40100
(2 required)
Compressor bolt assembly 07GAE-PG40200 or
07GAE-PG4020A
(U.S.A. only)
NOTE'
• Be sure the special tool is adjusted to have full
contact the stepped areas with the spring
retainer.
To prevenr loss of
Compress the return spring by tightening the nut.
spong tens/Ofl,
do
Remove the snap ring from the boss.
not compress more
than necessary.
The
M I
gear
bearing has one
roller miSSing from
each cage by
deSign
Loosen the nut and remove the special tools, snap
ring, spr ing retainer and return spring.
Wrap a shop l owel around the clutch drum .
Apply ai r pressure to the oil hole while closing the
other holes with your finger to remove the clutch
piston.
Remove the a -rings from the piston.
Clean all the parts of the shift clu tch in solvent thor-
oughly and blow dry them with compressed air.
INSPECTION
MAINSHAFTt COUNTERSHAFT
Check each gear tooth and need le bearing for
abnormal wear or damage.
Check the oil holes in the mainshaft and
countershaft for dogs.
DRIVETRAIN SYSTEM
SUPPC)RT
BLOCKS
COMPRESSOR BOLT
Support area
ATTACHMENT
RETURN SPRING
RING
NEEDLE BEARING M1
M3
14-49