Tire Assembly - Honda MUV700 big red Service Manual

Use only water
as a
IUOflcam when
(emoVlng
Of
mountmg tlfes
Soap or some
mountmg lubricants
may leave
a
slippery
reSidue which can
cause the fire
10
Shift on the rim and
lose
IN
pressure
durmg dovmg
If
a
plug has been inserted, trim it even with the
inner tire surface.
Temporarily place a rubber patch that is at least
twice the size of the puncture over the injury. Make
a mark around the patch, slightly larger than the
patch itself.
Rough the area marked inside the tire with a ti re
buffer or a wire brush. Clean the rubber dust from
the buffed area .
Apply cement over the area marked and allow it to
dry until tacky.
Do not touch the cement with dirty or greasy hands.
Remove the li ning from the patch and center over
the injury.
Press the patch against the injury using a special
roller.
ASSEMBLY
Install the tire onto the rim , where the rim shoulder
width is the narrowest, to simplify installation.
Clean the rim bead seat and flanges.
Apply clean water to the rim flanges, bead seat and
base.
Install the valve core in the valve stem.
Install the tire with the arrow mark facing in the nor-
mal rotating direction.
Inflate the tire to seat the tire bead.
Deflate the tire. Wait 1 hour and inflate the tire to
the specified pressure.
RECOMMENDED TIRE PRESSURE:
FRONT:
Standard: 70 kPa (0.70 kgflcm2, 10.0 psi)
With cargo: 70 kPa (0.70 kgf /cm2, 10.0 psi)
REAR :
Standard: 70 kPa (0.70 kgf/cm2, 10.0 psi)
With cargo: 70 kPa (0.70 kgf/cm2, 10.0 psi)
Check for air leaks and install the valve cap.
FRONT WHEEL/SUSPENSION
I
15-9