Honda MUV700 big red Service Manual page 406

STEERING SYSTEM
Apply 1 - 3 9 of grease to the inner surface of the
end bushing.
Install the bushing by aligning the bosses with the
grooves in the housing.
(1 - 3 g)
BUSHING
Apply 5 - 10 9 of grease to the teeth of the steering
~=============~===~
rack evenly.
Be careful nor 10 Insert the rack into the gear box housing slowly in
damage the
the direction as shown .
busfHng by rhe rack.
end edge
~
(5 - 10
g)
Apply grease to the needle bearing in the gear box
~=================~
16-16
housing and the ball bearing on the steering pinion .
Make sure the reck teeth cen be seen through the
pinion hole and insert a new pinion/bearing assem-
bly into the housing.
Press the bearing in until it is fully seated, using the
special tool.
TOOL:
Driver, 22 mm 1.0.
07746-0020100
DRIVER
I
~..v;;;..
"'... '
(0.2 - 0.5
g)
,.JiiM.
(0.2 - 0.5
g)