Honda MUV700 big red Service Manual page 335

2. Gear Position Switch Ins pection at peM
Connector
Turn the ignition switch OFF.
Disconnect the peM 33P black connector.
Check for continuity between the wire harness
side 33P black connector termina ls and ground.
There should be con t inuity in each gear position,
and no continuity in the other posit ion.
r-Gea r posit ion Connector tenninal
~ronve
Light
blueJWfii< t e i T. I A~2~ 4 n J--
j
~_~~utral)
19ht
green/ red
1 ;q7 ~
I " (Revers e) Gray
{~m
J
Are the test results normBI?
YES - GO TO STEP 4.
NO - GO TO STEP 3.
3. Gear Position Switch Inspection at Switch
Connector
DRIVETRAIN SYSTEM
PCM 33P BLACK CONNECTOR
(Terminal side of the wire harness)
Gray (A25) Light blue/whit e (A24)
Light greenJ
red (A17)
=
Disconnect the gear position switch 3P black , -- -- - -- - -- - -- - -- - ,
connector.
GEAR POSITION SWITCH 3P BLACK
Check for continuity between the switch side 3P CONNECTOR (Terminal side of the switch)
black connector terminals and ground.
There should be continuity in each gear position,
and no continuity in the other position.
~
ear position Connector
tennr.in~'''I---
O - (Dnve 19 t
ue
white
. (NeufriJ 19
t
green
- , everse ray
Are the test results normal?
YES
-
•
Open or short circuit in
the
Light
bluelwhite wire.
•
Open or short circuit in
the
Light
green/red or Light green wire.
•
Open m short circuit in
the
Gray
wi re.
NO - Faulty gear position switch.
4. Failure Reproduction
Connect the PCM 33P black connector and gear
position switch 3P black connector.
Erase the DTC (page 6-13).
Test·drive the vehicle and stop the engine .
Recheck the DTC with the HDS pocket tester.
Is Dre 41
· 1
indicated?
YES - Replace the PCM wi th a new one and
recheck.
NO - Intermittent failure.
Light bluelwhite
green
14-25