Honda MUV700 big red Service Manual page 263

CYLINDER INSTALLATION
Clean the gasket surface of the crankcase thor-
oughly, being careful not to damage them, and
being careful not to allow gasket material into the
crankcase.
Blow through the oil passage (stud bolt hole) in the
cylinder with compressed air.
Install the cam chain guide into the crankcase so its
end rests in the groove properly.
Install the dowel pins and a new gasket.
Apply engine oi l to the cylinder wall, piston outer
surface and piston rings.
Be careful not
10
Route the cam chain through the cylinder and install
damage the piston
the cylinder over the piston while compressing the
rmgs and cylmdef
piston rings with your fingers.
wall
Align the cam chain guide bosses with the grooves
i n the cylinder properly to seat the cylinder on the ___ \_---'
crankcase.
Tighten the three
Make sure that the cylinder touches the crankcase
outside bolts again
evenly. Install the four bolts and the clip stay and
after installing the
tighten them securely.
cylinder head cover
CYLINDER/PISTON
CHAIN GUIDE
10-9