Tp Sensor Reset Procedure - Honda MUV700 big red Service Manual

FUEL SYSTEM (PGM-FI)
MIL
IGNITION
SWITCH
6-52
TP SENSOR RESET PROCEDURE
NOTE :
• Make sure that the DTC is not stored in the peM
memory. If the DTe is stored, the reset mode will
not start.
,. Remove the dummy connector from the OLe
{page6-12l,
Short the OLe terminals using the special tool.
TOOL:
SCS connector 070PZ·ZY30100
CON NECTION: Brown/ red - Green
2. Disconnect the Eel sensor 2P black connector.
Short the wire harness side connector terminals
with a jumper wire.
3. Turn the ignition switch to ON (I).
The MIL stars blinking (reset receiving pattern).
Within 10 seconds after turning the ignition
switch to ON (I), disconnect the jumper wi re from
the 2P connector.
4. When the reset procedure is complete, the MIL
blinking changes from Reset Receiving Pattern to
Confirmation Pattern.
Turn the ignition switch to OFF (0).
If more than
10
seconds elapse or the procedures
are incorrect, the MIL stays on. Repeat the reset
procedures.
Gj)
Within 10 sec.
0
U - ' - - - - -
U l ;
ON
: 0.1 sec.
" I~I'~'
- - " "
0.3 sec. , .
I
0.3 sec.
;---'---'
• 1,2 sec.
I
• _ _ _ _ _ ..J ___ _
Reset Receiving Pattern
- - - - - - ! = ,'
='----'==-==-=~~.
Reset Confirmation Pattern
OFF
(Terminal side of
the wire harness)
(Stay on: Reset procedure is not complete)
ON
(I)
------ I
OFF (0)