Accessory Socket Inspection; Accessory Socket Replacement - Honda MUV700 big red Service Manual

LIGHTS/METERS/SWITCHES
Remove the indicator lens from the bulb socket by
prying it.
Remove the bulb socket from underside of the
instrument panel.
Pull the bulb out of the socket.
Pass the bulb socket through the instrument panel.
Install a new bulb into the socket.
Install the tens into the socket and fit the socket into
the instrument panel property.
Install the removed parts in the reverse order of
removal.
ACCESSORY SOCKET
INSPECTION
24-6
Remove the center frame cover (page 3-7).
Measure the voltage between the White/black
(+)
and Green H wire terminals of the wire harness
side 2P green connector.
There should be battery voltage with the ignition
switch turned to ON
(I),
If there is no voltage, check for brown ACe fuse (10
A) and an open circuit in the wire harness.
Remove the accessory socket cap.
Check for continuity between the White/black wire
terminal of the socket side 2P connector and bottom
center terminal of the socket, and between the
Green wire terminal and side wall terminal.
There should be continuity.
If there is no continuity, check the sub-wire harness
for open circuit.
If the sub-wire harness is
OK,
replace the accessory
socket.
REPLACEMENT
Remove the center frame cover (page 3-7).
Disconnect the 2P black connector from the acces-
sory socket.
Loosen the nut and remolle the accessory socket
from the center frame cOlier.
LENS
INSTRUMENT PANEL
/
BULB
j~
/
SOCKET