Acura 3.5 RL Manual page 244

Illustrated Index
NOTE:
• Use new O-rings when reassembling.
• Apply oil to O-rings before installation.
• Use liquid gasket, Part No. 08718 - 0001 or 08718 - 0003.
• Clean the oil control orifice before installing.
• Remove the balancer shaft (see page 7-3).
OIL PUMP
Overhaul, page 8-12
Inspection, page 8-14
Apply liquid gasket to
block mating surface.
O-RING
Replace.
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
8 x 1.25 mm
22 N-m (2.2 kgf-m,
16 Ibf-ft)
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
OIL SCREEN
OIL CONTROL ORIFICE
(HYDRAULIC TAPPET)
Remove with 6 x 1.0 mm bolt
and clean.
O-RINGS
Replace.
O-RING
Replace.
O-RING
Replace.
SNAP RING
Install with open
side facing up.
OIL FILTER
Replacement, page 8-5
OIL CONTROL ORIFICES
(CAMSHAFT JOURNAL)
Remove with 6 x 1.0 mm
bolt and clean.
O-RING
Replace.
WASHER
Replace.
DRAIN BOLT
14 x 1.5 mm
44 N-m (4.5 kgf-m, 33 Ibf-ft)
Do not overtighten.
OIL CONTROL ORIFICE
(HYDRAULIC TAPPET)
Remove with 6 x 1.0 mm bolt
and clean.
O-RINGS
Replace.
6 x 1.0 mm
12 N-m (1.2 kgf-m,
8.7 Ibf-ft)
BAFFLE PLATE
6 x 1.0 mm
12 N-m (1.2 kgf-m, 8.7 Ibf-ft)
LOWER BAFFLE
PLATE
DOWEL PIN
OIL PAN
Apply liquid gasket
to mating surface.
8 x 1.25 mm
22 N-m (2.2 kgf-m,
16 Ibf-ft)
O-RINGS
Replace.
OIL PAN INNER
PIPE
Clean before installing.