Adding Call Branding Entries - Avaya CS700 Administration And Maintenance

The last entry in the table consists entirely of wildcard characters. The number of characters in
this entry corresponds to the number of DNIS/DDI digits specified in the Digit Parameters
configuration.
Tip:
The last entry in the call brand table always needs to be a wild card entry, ????,
Tip:
assigned to message number 208. This entry captures any wrong number and no
company name specified, and its function is set to ENTER (the call is placed in
the Enter Queue for operator assistance).
For example, if the number of DNIS/DDI digits is set to 4, the default (last) entry in the table is
????. The system uses this entry for any line that does not match a specified DNIS/DDI
number.
You can add, modify, and delete call branding entries using cbutil.
Note:
You must configure the Digit Parameters before branding calls. See
Note:
Parameters

Adding Call Branding Entries

Use the cbutil add command to add a new entry to the Call Branding table.
Use this Syntax:
add <dnis> <rg> <msg> <ps> <ucps> <func> [-l <ln> -c <cn>]
where Table 15
Note:
Always enclose the number or line parameter entries in quotation marks. Failure
Note:
to enclose these entries in quotes may result in Unix attempting a substitution
which will cause the command to fail.
on page 85 for more information.
describes each parameter.
Branding Calls using cbutil
Digit
Issue 1 August 2007 87