Flex Configuration Settings - Avaya CS700 Administration And Maintenance

Configuring System-Wide Settings

Flex Configuration Settings

This section describes the required bridge settings for configuring Flex conference features.
See Table 12 to configure Flex system settings.
Table 12: Flex Configuration Settings
System Administrator
Main Menu >
Configurations >
System Configuration
Configurations >
System Configuration
Configurations >
System Configuration
Configurations >
System Configuration
Configurations >
Voice Message
Configuration
Configure Scheduler
76 Administration and Maintenance of the CS700/CS780 Audio Conferencing Server
Parameter / Setting
Moderator Lecture =
ON
Self Mute = ANYONE
Entry Tone = 1 beep or
2 beeps
Exit Tone = 1 beep or 2
beeps
Security Code Error
1&2 and Security Code
Error 3 = Tone or
Message, but not Both
On-Demand Pct.
To
Enable conference leaders to mute/
unmute non-leader line
Enable participants and moderators to
mute their lines.
Set the number of beeps in the entry tone
played to a conference when a
participant enters a conference
Set the number of beeps in the exit tone
played to a conference when a caller
exits a conference:
Enable security code error messages to
be played.
Note: When Security Code Error 1&2 is
set to TONE and an invalid code is
entered, then no message is played (only
the tone plays). The user may still enter a
correct Security Code. However, if on any
attempt, no security code is entered, then
the tone plays but the system does not
allow further attempts. The line is either
hung up or placed in the Enter queue.
If Security Code Error 3 is set to TONE,
then only the tone is played and the line
is either hung up or placed in the Enter
queue.
Enable Flex calls to be scheduled. On
demand percentage must be set from
1-100 as Flex calls use on demand ports.
1 of 3