Mandatory Billing Codes For Systems Configured With Flex - Avaya CS700 Administration And Maintenance

To construct EPV commands, you append the cmdtok parameter to an http request sent to the
URI defined by cmdURI. This parameter identifies which command the system is requesting.
The cmdtok parameter is followed by a set of command-specific parameters.
Currently, the only supported command updates the Leader PIN in a Flex conference. The
cmdtok parameter for the Update Leader PIN command:
cmdtok=1
The following example shows the full http request used when sending the Update Leader PIN
command to the default cmdURI:
http://<epv_server>:8080/epvtest/epvcmd.html?
cmdtok=1&
confID=<conferenceID>&
v=1.0&
bn=<bridgename>&
lp<leaderPIN>&
ent<EntryTones>&
exit<ExitTones> &
qs<QuickStart> &
mh<Modhang> &
nrp<NRP>
!
Important:
This example assumes that the EPV server returned a valid Conference ID that is
Important:
a unique identifier for any given schedule.
Example cmdURI within chdbased.reg
[xmldatasource]
version=1.0
bridgeid=edison
installed=true
name=xmldatasource
address=epv
URI=/epvtest
pingURI=/epvtest/epvping.html
cmdURI=/epvtest/epvcmd.html
port=8080
test=false

Mandatory billing codes for systems configured with Flex

The system can prompt the leader to provide a billing code for their conference when entering a
Flex flow conference. To make the billing code mandatory, set the following parameter:
<forceAuxCode>=1 (Set this field to 0 to not require the billing code)
If this field is set to 1, the leader will be disconnected if he fails to enter the billing code after
three attempts.
Using External Passcode Validation
Issue 1 August 2007 185