Avaya CS700 Administration And Maintenance page 151

Table 27: T3config.txt file Settings (continued)
<Section>
Parameter
DIALDELAY
DNISDIGITS
DNISTIMEOUT
DNISPATTERN
ANSWER
OUTDIAL
CALLROUTING
SWITCHTYPE
TYPENUM
TYPEPLAN
Setting
Valid settings are 50 — 1000 milliseconds.
The default value is 100 ms.
Defines the number of DTMF digits the system expects
to receive during call set-up. These digits include all
ANI, DNIS, and delimiters specified by the
DNISPATTERN. The setting must match the value sent
by the T3 provider during call setup.
Valid settings is 1 — 40 digits.
The default value is 4.
Defines the maximum time allotted by the system for
DNIS digit collection.
Valid settings are 1000 — 20,000 milliseconds.
The default value is 4000 ms.
Defines the pattern or order in which the system
receives the digits. Valid delimiter characters are *, &, #,
and <A> for ANI and <D> for DNIS.
The ANI and DNIS setting must match the value sent by
the T3 provider during call setup. For example, when
the DNISPATTERN is set to:
expects *anidigits*dnisdigits*, in that order.
Note: Leaving this setting blank results in <D> or a
DNIS only pattern.
Valid settings are: Yes and No.
Set this to Yes.
Valid settings are: Yes and No.
Set this to Yes.
Valid settings are: Yes and No.
Set this to Yes.
Used for ISDN configurations.
Valid settings include: NONE, NI2, 4ESS, 5ESS and
DMS100
Used for ISDN configurations.
Valid settings include: UNKNOWN, INTERNATIONAL,
NATIONAL and LOCAL
Used for ISDN configurations.
Valid settings include: UNKNOWN, ISDN and PRIVATE
Configuring T3
the system
*<A>*<D>*
2 of 4
Issue 1 August 2007 151