Avaya CS700 Administration And Maintenance page 153

Table 27: T3config.txt file Settings (continued)
<Section>
Parameter
CLOCK_DRIVER_SOURCE
IP_Address
2
TRUNKS
CALLING
1. The order of transports listed in the netservices.reg file determines the network source that provides
the clocking to C8A. For example, when the file lists ' pstn ' then ' t3 ' , the T1 card network trunks
start first and provide clock. When the file lists ' t3 ' then ' pstn ' , the T3 card network trunks start
first and provide the clock.
2. There can be multiple TRUNKS and CALLING lines. Each TRUNKS and CALLING lines can have
multiple entries separated be spaces.
Setting
Valid settings include:
Internal
l
C8A
l
TRUNKn, where n is 1 - 28.
l
The IP address of the T3 card.
<trunk>:<id>
TRUNKS=3:3
or
<starting trunk>-<ending trunk>:<id>
TRUNKS=1-2:2 4-28:2
Tip:
The <id> is from the <Profile ID> section
Tip:
at the top of the file. For example, 1 is
the id for Profile 1.
!
Important:
Each TRUNKS setting must use an id to
Important:
specify the Profile, or the conversion
process fails and the data file is not
generated.
<trunk>:<id> or
<starting trunk>-<ending trunk>:<id>
CALLING=1-9:1 10-19:2 20-28:3
Note:
This <id> is the id from the line in the
Note:
<Calling-Numbers> section. If the id is
not defined the conversion process fails
and the data file is not generated.
Configuring T3
4 of 4
Issue 1 August 2007 153