Avaya CS700 Administration And Maintenance page 358

System and Log Messages
Table 8: Status Message Definitions (continued)
Message
Code
0118
0119
0120
0121
0122
0123
0124
358 Administration and Maintenance of the CS700/CS780 Audio Conferencing Server
Message
Cannot find channel %d in
conference %d
DSP %d semaphore %d not
available
DSP %d installed, supports
network line %d
Error defining alarm in alarm
database
Event %d out of sequence on
channel %d
Initiating network device cold
restart
Initiating network device warm
restart
Meaning
Whenever a channel is placed into a
conference, it is always moved from
one conference to another. This error
indicates that the channel could not
be found in its previous conference.
The channel still ends up in the new
conference. This error indicates that
the internal database has been
corrupted.
The host attempted to obtain the
specified semaphore while the
semaphore was locked by the
specified DSP.
During initialization, the specified DSP
was detected.
The system has attempted to define
an alarm but the alarm definition table
is full. Internal debug error only,
should not occur in production
software.
A DSP event was not received in the
correct sequence. This usually
indicates that the host was expecting
notification from a DSP that one
annunciator buffer was ready and
instead received notification about the
other.
Indicates that the network devices
(trunks) in the system are being
restarted. Cold indicates that the
trunks will be re-initialized.
Indicates that the network devices
(trunks) in the system are being
restarted. Warm indicates that the
current states of the trunk will not be
affected.
4 of 9