Configuring Trunks On T1/E1 - Avaya CS700 Administration And Maintenance

When PSTN is not available on the system, for example only T3 networks are supported,
the menu looks like this one:
Network Configuration Menu, PSTN not installed
2. Select the desired menu option and change settings as necessary. See the following
sections for details:

Configuring Trunks on T1/E1

l
Trunk Status
l
Trunk Enable and Disable
l
Load the Inbound Port Group Configuration
l
T3 Loopback Enable/Disable
l
T3 Trunk Enable
l
3. Save (or cancel) your changes.
Configuring Trunks on T1/E1
The Trunk Configuration
settings.
Trunk Configuration
+---- Network Configuration ----+
¦
¦ T3 Loopback Enable/Disable
¦ T3 Trunk Enable/Disable
¦ Load Outbound Port Group Cfg ¦
¦ Load Inbound Port Group Cfg
¦
+-------------------------------+
on page 131
on page 142
on page 144
on page 145
on page 146
menu includes options that you select to view and configure trunk
+-----Trunk Configuration------+
¦
¦ Synchronization & Monitoring ¦
¦ Layer 1 Configuration
¦ Signaling Details
¦ Set Board Count
¦ Apply trunk 1 to all trunks
¦ Apply Changes
+------------------------------+
Configuring Network Settings
MAIN MENU
on page 147
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
¦
Issue 1 August 2007 131