4000-4999: Hardware And Device Messages - Avaya CS700 Administration And Maintenance

4000–4999: Hardware and Device Messages
Table 12: Hardware and Device Messages
Message Code
4000
4001
4007
4008
4009
4010
4011
4012
4013
Message
Annunciator ready event
%d failed for channel %d
Cannot get attributes for
output device
Error %d: [%s] during
network driver operation:
%s
Cannot set attributes for
output device
Cannot configure analog
board
Cannot get DSP memory
address
Cannot get DSPs installed
Cannot get active DSP
nodes
Cannot get/return interrupt
vector
Log Message Codes
Meaning
An attempt to report to the
annunciator process that
the specified buffer is ready
for the logical channel
failed.
A TCGETA call to ioctl
returned an error.
Indicates that a network
driver error occurred. This
occurs only when the
network software loses
synchronization. with the
network driver (for
example, after system
reinitialization).
A TCSETAF call to ioctl
returned an error.
An attempt to configure the
analog board failed.
An attempt to get the
physical address at which
DPM is mapped from the
DSP driver failed.
An attempt to determine
the installed DSPs from the
DSP driver failed.
An attempt to determine
the active DSPs from the
DSP driver failed.
An attempt to acquire or
return control of an
interrupt vector for testing
purpose failed.
Issue 1 August 2007
1 of 8
371