Avaya CS700 Administration And Maintenance page 63

Use this procedure to configure system supervision settings:
1. Select System Administrator Main > Configurations > Supervision Configuration.
The system displays
Figure 14: Supervision Configuration Screen
Figure notes:
The Dial Delay and Wink Timeout settings are not supported for this release
l
See Signaling Details and Configuration
l
2. Set parameter values.
Table 8 lists and describes parameters.
3. Save (or cancel) your changes
.
Table 8: Supervision Configuration Parameters
Parameter
Annunciator Delay
Dial Delay
Supervision Configuration
Description
Specifies the pause before the system plays a message to an
incoming line.
To specify a delay enter a value of 1 to 5 seconds (0 is the
default).
To determine if a delay is necessary, simply dial into the system
and listen to the annunciator message.
Specifies the pause (line remains off hook) before the system
begins dialing digits.
This delay verifies dial tone. Valid time intervals range from 1
(default) to 5 seconds. Consult your phone network provider to
determine the most suitable dial delay for your system.
Note:
Not supported in this release.
Note:
Screen.
on page 137.
System Supervision
1 of 4
Issue 1 August 2007 63