Installation Of Lower Unit - TOHATSU MFS 9.9 Owner's Manual

37) Installation of Lower Unit

1. Set cam rod to reverse (R) position.
Connect water pipe securely. Move flywheel a
little or shift gear into reverse (R), install
propeller,
counterclockwise to engage spline.
2. Attach lower unit ass'y to drive shaft housing, and tighten
lower unit installation bolts (nuts) 1 to specified torque.
Gear Case Installation Bolt (Nut) 1 :
13 N · m (9 lb · ft) [1.3 kgf · m]
3. Set both engine side and gear case side gear shifts to
neutral (N).
4. Connect shift rod and cam rod with new spring pin.
Bevel Gear B Nut Socket 2 :
P/N. 345-72228-0
· Before removing or installing propeller, be
sure to disconnect battery cables from
battery and remove stop switch lock plate.
· When removing or installing propeller, do
not handle propeller with bare hands.
· Put a piece of wooden block between anti-
cavitation plate and propeller to prevent
rotation of propeller.
4st 9.9/15/20 2008
and turn propeller
WARNING
shaft
A
A
"UL" Transom Model
2
F
N
R
1342 1342
1342
TEF
TEF
1
6
6-29