Installation Of Lower Unit - TOHATSU TLDI MD 115A SERIES Service Manual

Lower Unit

32) Installation of Lower Unit

Set shift rod 1 to up position.
1.
· Apply thin coat of OBM grease to spline of
drive shaft before assembling.
· Apply thin coat of OBM grease to water pipe
seal rubber.
· Lower unit installation can be made easier with
the outboard motor tilted up.
· When installing the lower unit, insert water
pipe into seal rubber properly.
2. Put lower unit ass'y into drive shaft housing.
Connect speedometer pick up tube 2, and align positions
of water pipe and water pipe seal 3.
3. Tighten lower unit ass'y installation bolts and nut to
specified torque.
4. Attach gear case plate plug 1 and gear case plate 2.
To make centering of lower unit ass'y to
drive shaft housing, attach bolts to two
locations marked on the lower unit ass'y
B
first. After all bolts are attached, tighten
the two bolts first.
M8 :
25N · m (18 lb · ft) [2.5kgf · m]
M10 :
40N · m (29 lb · ft) [4.0kg · m]
6-38
CAUTION
1
3
2
B
M10
M8 M8
M8
OBM OBM
OBM
UL
L
OBM OBM
OBM
OBM OBM
OBM
2
1
1342
1342
M10
TLDI 115A 2007