Measurement Of Propeller Shaft Play And Selection Of Washer Thickness - TOHATSU TLDI MD 115A SERIES Service Manual

Lower Unit
36) Measurement of Propeller Shaft
Play and Selection of Washer
Thickness
Before measuring propeller shaft play,
adjust backlash between forward (A) and
pinion (B) gears and reverse (C) and pinion
(B) gears.
Refer to "Measurement of Backlash
between Forward (A) and Pinion (B) Gears
and Shim Selection" and "Measurement of
Backlash between Pinion (B) and Reverse
(C) Gears and Shim Selection" in Chapter 6.
1. Assemble lower unit parts in accordance with procedure
described in "Assembling Lower Unit Parts" in Chapter 6.
2. Measure play of propeller shaft in forward and reverse
directions.
Select washer 1 thickness so that the play is within the
3.
specified range.
Specified Value of Play :
0.2 - 0.4 mm (0.0078 - 0.0157 in)
Type of Washers :
2.8 mm (0.110 in) P/N. 3B7-64035-0
3.0 mm (0.118 in) P/N. 3B7-64034-0
3.2 mm (0.126 in) P/N. 3B7-64032-0
Replace washer 1 between propeller shaft 2 and reverse
4.
(C) gear 3 if necessary.
For removal or installation of propeller shaft
housing, refer to;
"Removing Propeller Shaft" and "Assembling
Lower Unit Parts" in Chapter 6.
6-48
CAUTION
CAUTION
3
2
1
TLDI 115A 2007