16) Inspection of Propeller Shaft Ass'y
1.
Check propeller shaft for bend, wear and damage.
Replace if necessary.
2.
Measure propeller shaft runout.
Runout Limit :
0.05 mm (0.0020 in)
Check clutch dog b and push rod c for crack and wear.
3.
Replace if necessary.
17) Assembly of Propeller Shaft Ass'y
Attach spring 6, spring retainer 5, steel balls 2 (3 pcs.),
1.
push rod 1, clutch 7 and clutch pin 4 to propeller shaft.
· When attaching clutch, face the narrower claw
a to push rod side.
· When installing spring retainer, direct the end
farther away from the hole toward forward gear
a.
· Install clutch pin while applying preload to
push rod.
· Apply OBM grease to spring retainer to prevent
ball from dropping.
· Be careful not to allow ball to fly out by spring
tension.
OBM
OBM
OBM
OBM
TLDI 75/90C2 2010
a
a Supporting Points
c
b
3
7
6
OBM
OBM
OBM
OBM
2
1
4
5
3 Clutch Pin Snap
Do not reuse.
a
a
6
6-21