Toshiba VP 300 Installation Instructions Manual page 99

➧
NO Determine the cause and correct the problem before continuing.
C. Repeat the procedure from step A for each trunk until all hunts have been tested. Verify that
each trunk is answered by the VP 300 with the correct greeting.
1-800 (InWATS) lines can be tested individually, even if they are bands from other areas,
by using the "plant test" number. Get these from the CO if you do not already know them.
11. CALLS TO THE INTERCEPT EXTENSION
Verify that the VP 300 can transfer a call to the Intercept position (attendant) when the caller
does nothing or dials 0.
A. From telephone A, call the extension associated with port 1.
B. Does the VP 300 answer correctly?
C. Listen to the complete company greeting. Do nothing and let the VP 300 time-out and transfer
the call to the attendant.
D. Did you reach the attendant?
YES ➧
Continue for all ports.
➧
NO Determine the cause and correct the problem before continuing.
E. Repeat the procedure by dialing 0 instead of waiting for time-out.
F. From telephone A, call out and back in on a trunk dedicated to the hunt group. When the VP
300 answers, let the system time out (do not enter any digits).
G. Does the VP 300 transfer the call to the Intercept position?
YES ➧
Continue.
➧
NO Determine the cause and correct the problem before continuing.
12. MESSAGE WAITING
A. From telephone A, call out and back in on a trunk dedicated to a VP 300 port.
B. Does the VP 300 answer properly?
YES ➧
Continue.
➧
NO Determine the cause and correct the problem before continuing.
C. Make sure telephone C is busy by taking it off-hook. Enter the extension number associated
with telephone C.
D. After a predetermined interval, the VP 300 should reconnect, and at telephone A you should
hear, "Extension XXX is busy. Please leave a message at the tone, dial another extension
number, or dial zero for assistance."
INSTALLATION 3-43
Toshiba VP Systems Release 7.1 July, 1994