Table of Contents
Advertisement
Command
Basic Definition
TE C 2 [X] [Y]
TEST CHANNEL 2 (X = Port number or first port in a range of ports. Y =
Last port in a range of ports.)
If a port or range of ports is specified (X [Y]), the system tries to initialize and
cancels forwarding for the port(s) specified. If no port is specified, the system
tries to initialize and cancels forwarding for all ports. If a port successfully
initializes and cancels forwarding, it goes to the IDL state. If a port fails to
complete either the initialization or cancel forward string, it is left in the NDT
state.
TE F 1
TEST FLOPPY 1
Reads each sector on the floppy diskette and reports on any errors detected. This
test does not verify data on the diskette for accuracy.
TE L 1
TEST LINE 1
Tone reflection test. Ports that fail are left in a test state.
TE L 2
TEST LINE 2
Tests ring through capability of all the ports.
TE L 4 [X]
TEST LINE 4 (Release 6.1 or later)
Test to see if loop current is present on a specific port.
X is the port number. The port number must be entered in decimal.
TE L 5 [X]
TEST LINE 5 (Release 6.1 or later)
Tone reflection test on one port.
X is the port number.
TE NET (NET
TEST NETWORK (NETWORK LOCATION) (X = Non zero show
LOC) X
digits dialed)
Tests network routes to a network location. Tests all locations if no network
location is specified.
TE S
TEST STATUS
Tests the VP 300 temperatures and voltages.
TE INT n m
TEST INTEGRATION
Tells the integration card to run its link selftest. Used only for systems with
integration cards.
n = slot number
m = unit number
MAINTENANCE
Toshiba VP Systems Release 7.1
July, 1994
5-5
Advertisement
Chapters
Table of Contents
