Toshiba VP 300 Installation Instructions Manual page 187

Result Code
result: 00 Successful fax transaction
result: 01 Fax protocol error
result: 02 Default error code
result: 03 Modem training failure
result: 04 Remote fax requested a feature which is not supported by the Toshiba VP System
result: 05 Not used
result: 06 Voice bus timeout
result: 07 Fax protocol error
result: 08 VCU not ready
result: 09 Bad page retransmit limit reached
result: 0A Modem connection failure. No response from on-board modem
result: 0B Modem connection failure
result: 0C Other side disconnected
result: 0D Operator assistance not supported in fax
result: 0E Fax system ID match
result: 0F No fax or busy line
result: 10 Transmission fail in HDLC test. Used in fax loopback test. Hardware error 63 is
logged
result: 11 Receiver fail in HDLC test. Used in fax loopback test. Hardware error 63 is logged
result: 12 Both transmitter and receiver failures in HDLC test. Used in fax loopback test.
Hardware error 63 is logged
result: 13 Timeout occurred in HDLC. Used in fax loopback test. Hardware error 63 is logged
result: 14 No identification frame record from remote fax
result: 15 Remote fax did not respond to command
result: 16 Unable to configure remote fax
result: 17 Remote fax did not confirm Toshiba VP system's transmission fax parameters
result: 18 Hardware training failed. No carrier
result: 19 No response from RX for multi-page signal
result: 1A Unexpected frame from remote fax
result: 1B No response from remote fax to End of Procedure frame
result: 1C No response from remote fax to End of Message frame
result: 1D No response from remote fax to Identification frame
result: 1E Failure in receiving command frame from remote fax
result: 1F Remote fax failed in retransmitting bad page and disconnected
result: 20 Remote fax disconnected due to resolution mismatch
Definition
Toshiba VP Systems Release 7.1
5-29
MAINTENANCE
July, 1994