Fax Application Processor - Toshiba VP 300 Installation Instructions Manual

5-84 Installation and Maintenance Manual
CARD EJECTOR
RED
GREEN
AMBER
SIMM MODULES
CARD EJECTOR
Removing Fax
Application
Processors
Toshiba VP Systems Release 7.1 July, 1994
SIMM MODULES
CARD STIFFENERS
ORIENTATION LABEL
FRONT
FAX DAUGHTER CARD 2 (CHANNELS 5-8)
(SOLDER SIDE UP)
FRONT
FAX DAUGHTER CARD 1 (CHANNELS 1-4)
(SOLDER SIDE UP)
Figure 5-8 Fax Application Processor
The procedure to replace a Fax Application Processor is as follows:
1. Take the fax card out of service. At the @ prompt enter:
CDFAX x
Enter
where x is the slot number of the fax card.
2. Unlock and open the door of the cabinet.
3. Put on an antistatic wrist strap. Connect it to an unpainted portion of the
cabinet.
4. Remove the fax card from the Toshiba VP System cabinet by pivoting the
plastic card ejectors on the top and bottom of the front edge and sliding the
card out of the card cage.
Handle the fax card only by the top and bottom edges. Do not touch
components on the card.
5. Store the fax card in a static protection bag.