Toshiba VP 300 Installation Instructions Manual page 97

F. Does the call divert to the correct alternate answer point when the VP 300 does not answer?
G. Reconnect the modular line cords.
H. From the terminal, type TE C 1. The VP 300 should respond showing each port forwarded
(PORT X FORWARDED) until all ports have been forwarded.
I Type PS to verify all ports are in the FWD (forwarded) state.
J. From telephone A, dial the hunt group extension number or access code.
K. Does the call forward to the correct position as specified in the call forwarding string (System
Parameter 45 — SYSTEM RELOAD FORWARD STRING.)?
YES ➧
Continue.
➧
NO Determine the cause and correct before continuing.
L. From the terminal, type TE C 2 to cancel call forwarding. The VP 300 should respond with
ALL PORTS INITIALIZED.
M. From telephone A, dial the hunt group extension number or access code.
N. Does the VP 300 answer correctly?
YES ➧
Continue.
➧
NO Determine the cause and correct before continuing.
O. Type PS at the terminal.
P. Verify that all ports are in the IDL state and that the cancel forwarding string (System
Parameter 46 — SYSTEM RELOAD CANCEL FORWARD STRING) is correct. If any ports
still show FWD, use TE C 2 x, where x is the port number, to cancel forwarding. If cancel
forwarding does not work, determine the cause and correct before continuing.
9. VERIFYING TRUNK TO VP 300 OPERATION
Verify that the VP 300 can properly handle trunks.
A. From the terminal enter the PS command.
B. Does the port status show all ports in the IDL state?
YES ➧
Continue.
➧
NO Determine the cause and correct the problem before continuing.
C. From telephone A, call outside of the PBX and back in on trunks dedicated to the hunt group.
D. Does the VP 300 answer properly?
YES ➧
Continue.
➧
NO Determine the cause and correct the problem before continuing.
E. From the terminal, enter the PS command..
INSTALLATION 3-41
Toshiba VP Systems Release 7.1 July, 1994