Toshiba VP 300 Installation Instructions Manual page 380

6-66 Installation and Maintenance Manual
Action
8. Press
9. @DSKTST
10. If more than one drive
is being replaced, repeat
step 9 for each drive
replaced.
11. @DSKMAP
12. Remove the Release 5
Software Diskette from
the FD.
Test Diskettes
13. Insert a diskette into the
floppy drive.
14. @TE F 1
15. Repeat steps 13 and
14 for each diskette.
Choose the Correct
Disk Option
16. Reinsert the Release 5
Software Diskette #1
into the FD.
Toshiba VP Systems Release 7.1 July, 1994
VP 300 Description and Response
twice To log on to the VP 300.
Enter
Run on the replaced drive slot. Causes the VCU to test the slot and
Enter
update its status record.
To view the status of all drive slots.
Enter
Each diskette (Release 5 Software Diskette, prompt diskette, and the
backup configuration diskette) must be tested before completing the
remainder of this procedure.
VP 300 prompts:
Enter
TEST 01 COMPLETE
If any diskette fails the test, a replacement must be obtained before
continuing with this procedure. Refer to MAINTENANCE, Floppy
Disk Drive (FD) Diagnostics section, for a description of this
diagnostic.