Table of Contents
Advertisement
D. Answer the Superset. Transfer phone A to the attendant by pressing the TRANS/CONF
softkey, dialing 0, and pressing the HANG UP softkey. Does phone A get connected
to the attendant?
➧
NO
E. Connect the Superset to the RJ11 jack of the next MIC port extension and make sure
the phone initializes and displays the time and date. Repeat steps B through D for each
MIC port until every MIC port has successfully transferred a call to the attendant.
The PBX testing is now complete. Proceed with installation of the MIC board(s). Do not
connect any line cords to the VP 300 until after all MIC boards are installed.
I
Installation of the MIC Board
This section describes the procedure for installing the MIC board (VP-4PMIC). Before
proceeding with installation, note that there are six LEDs on the front edge of the MIC, near the
top of the card. These are used to indicate card status and are, from top to bottom,
LED Name
DOWN LED
GOOD LED
Port 1 LED
Port 2 LED
Port 3 LED
Port 4 LED
The installation procedure refers to the LEDs by the above names.
After the PBX tests have been successfully completed and the VP 300 ports reconnected to the
PBX, proceed with the installation of the MIC using the following procedure.
1. Forward the VP 300 port extensions by entering, at the @ prompt:
TE C 1
2. Remove any VP 300 line cards that are to be replaced by MIC boards.
3. Plug the MIC board(s) into the VP 300 cabinet.
Verify that the cables for all cards are attached and all PBX wiring has been
completed.
The MIC goes through a power-ON routine, which takes about 30 seconds. When the
routine is finished, the MIC begins to download its program code from the VP 300 VCU.
While the MIC is downloading, both the Red and Green LEDs are ON. If the Red LED
remains on after three minutes, there is a problem. Call Toshiba technical support.
MITEL SX-100/SX-200 ANALOG ADAPTIVE INTEGRATION
Determine the cause and correct the problem before continuing.
LED Color
Red
Green
Yellow
Yellow
Yellow
Yellow
Toshiba VP Systems
Release 6.1
10.2-27
February, 1993
Advertisement
Chapters
Table of Contents
