Continued - Toshiba VP 300 Installation Instructions Manual

Table 10.3-4
VP 300 Configuration Changes for MWI and CPI (continued)
Item Description
15. Modify System Parameter 85 to be F.
16. Modify System Parameter 106 on the SLOTS Table for
MWI, if applicable.
17. Modify System Parameter 116 to be YES.
18. Modify System Parameter 117 to 5.
19. Modify System Parameter 131 to be YES.
20. For SX-2000 Systems not using the COV Voice Mail Port
class of service option, modify System Parameter 170 to
be YES.
21. Modify the value of System Parameter 191 to be the hour
when the VP System should automatically update Message
Waiting Indicators.
22. Modify the SLOTS Table so that all integrated ports are in
AX mode and that all ports are configured for outcall
except the port used for MWI. Set testing to NO for all ports.
Table 10.3-5
After All VP 300 Configuration Changes Are Complete
Item Description
1. When you exit the UPDATE after making the necessary changes, the
VP 300 prompts:
FOR CHANGES TO TAKE EFFECT, SYSTEM MUST BE RESTARTED.
2. Restart the system.
Table 10.3-6
Item Description
1. Configure the required test extensions.
2. Perform pre-installation testing.
3. Install the MIC boards in the VP 300 and connect the Superset lines.
4. Perform Adaptive Integration operational tests.
MITEL SX-2000 ADAPTIVE INTEGRATION
Command
.M SYS 85
.M SYS 106
.M SYS 116
.M SYS 117
.M SYS 131
.M SYS 170
.M SYS 191
.M SLOT
Installation and Testing
Toshiba VP Systems
10.3-53
Complete
Complete
Complete
Release 6.1 February, 1993