Toshiba VP 300 Installation Instructions Manual page 395

Action
8. :DSKTST
Enter
9. If more than one drive is
being removed, repeat
step 8 for each drive
replaced.
10. :DSKMAP
Enter
Test Diskettes
11. Press twice.
Enter
12. :DSKTST
Enter
13. :DSKMAP
Enter
14. Repeat DSKTST for
each drive that is
added.
Choose the Correct
Disk Option
15. @DISKO
Enter
VP 300 Description and Response
Run on the drive slot added. Causes the VCU to test the slot and update
its status record.
Views the status of all drive slots.
Each diskette (Release 5 Software Diskette, prompt diskette, and the
backup configuration diskette) must be tested before completing the
remainder of this procedure.
To log on to system.
Run on the drive slot added so that the VCU will test the slot
and update its status record.
Reviews the status of all drive slots.
The following menu is presented:
CURRENT STATUS
Slot Type ID Status
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
B3 System1 S1 ACTIVE
B4 System2 S2 EMPTY
C1 Voice1 – – EMPTY
C2 Voice2 – – EMPTY
C3 Voice3 – – EMPTY
C4 Voice4 – – EMPTY
DISK OPTIONS
1. ADD DISK
2. REMOVE DISK
3. REPLACE A DISK
4. RESTORE SYSTEM
Select option to be performed
(1–5, – Empty line = EXIT)
PROCEDURES
Configured
Configured
Configured
Not Configured
Not Configured
Not Configured
Not Configured
Toshiba VP Systems Release 7.1 July, 1994
6-81