Hard Disk Remove For Release 5.3 And Earlier - Toshiba VP 300 Installation Instructions Manual

6-80 Installation and Maintenance Manual
I Hard Disk Remove for Release 5.3 and Earlier
This section provides the procedures to follow when removing a drive from a multiple-drive system.
This procedure applies when you intend to remove a disk without immediately replacing it.
Action
Remove the Drive(s)
1. Turn OFF the power to
the VP 300.
2. Remove the hard disk(s)
from the system.
Boot the System
3. Make sure the Release 5
Software Diskette #1 is
write-protected.
4. Insert the Release 5
Software Diskette #1
into the FD.
5. Adjust the baud rate of
the terminal/teleprinter to
300, 1200, or 9600 baud.
6. Turn ON the power to
the VP 300. With the
teleprinter baud rate set,
press
7. Press
Toshiba VP Systems Release 7.1 July, 1994
VP 300 Description and Response
Allows the hard disk drives to spin down to a complete stop before you
begin to work on the system.
Refer to MAINTENANCE, Hard Disk Drive (HD) Replacement, for
Hard Disk Removal procedures.
The following messages are printed:
twice.
Enter
CPU
. . . .. 05MB . . . . . . . . . . 1200 BAUD MODEM . . . . . .
BOOTING FROM FLOPPY DISK
. . XBOOT . . .
- - - - - - - - SYSTEM SOFTWARE RELEASE L.5.3.1 (MM/DD/YY) - - - - - - - -
DAY MM/DD HH:MM:SS YYYY ID:000 S/N:00000 PBX: 00
(MODEM ENABLED) LAST LOGON: MM/DD HH:MM
@WAITING FOR VCU READY
LOADING VCU WITH FILE F:VCU
VCU STARTED
SYSTEM INITIALIZATION SUSPENDED!
PASSWORD:
At this point, the VP 300 has completely booted from floppy.
twice. To log on to the VP 300.
Enter
Model 300-6004-101 Rev A1