Continued - Toshiba VP 300 Installation Instructions Manual

5-66 Installation and Maintenance Manual
Error Type:Name
33: Line Card
Hardware Error
The DATA-1 field specifies the type of error. DATA-2 and DATA-3 are data associated with
the error.
DATA-1 =
00 --
DATA-2 =
00 --
01 --
02 --
03 --
04 --
05 --
06 --
89 --
DATA-3 =
00 --
01 --
02 --
03 --
01 -- NO PORTS CONFIGURED FOR LINE CARD
02 -- LINE CARD DISALLOWED BY OCC
03 -- TOTAL PORTS > ALLOWED BY OCC
04 -- ERROR WRITING START LSP REQUEST TO VCU
05 -- DISK ERROR WHEN SEARCHING FOR LSP CODE A
Toshiba VP Systems Release 7.1 July, 1994
Table 5-3 Hardware Error Types and Remedies (continued)
Source
Error logged by
selftest when start
LSP reply received
with either an error
status or an
unexpected OK
status (e.g., Slot is
empty or already
reported down)
REPORTED STATUS
START LSP REPLY RECEIVED WITH EITHER AN ERROR STATUS
OR AN UNEXPECTED OK STATUS
REPORTED STATUS
LSP SUCCESSFULLY STARTED
SCSI ERROR WHILE LOADING LSP
DATA-4: VCU ERROR CODE
CARD TYPE IN SLOT DOES NOT MATCH CONFIGURED
TYPE
DATA-4: CARD TYPE ACTUALLY INSTALLED IN SLOT
CONTROL BUS ERROR - SLOT EMPTY OR CARD
NON-RESPONSIVE
FILE SYSTEM READ ERROR ACCESSING LSP IMAGE
CARD IN SLOT REPORTS FATAL DIAGNOSTIC ERROR
DATA-3: SUPPLEMENTAL CARD STATUS
BAD START LSP REQUEST
LIC REPORTED LIC IMAGE CHECKSUM ERROR
CURRENT SLOT STATE
EMPTY (UNCONFIGURED)
WAITING FOR INITIAL START LSP REPLY
RUNNING
ERROR
Remedy
Contact Toshiba Technical Support.
Priority
3