Hard Disk Replace For Release 5.3 And Earlier - Toshiba VP 300 Installation Instructions Manual

I Hard Disk Replace for Release 5.3 and Earlier
These procedures provide the steps to replace a hard disk drive on a system where the VP 300 is
configured as a multiple-drive system.
Action
Replace the Hard
Disk
1. Turn OFF the power to
the VP 300.
2. Remove the hard disk(s)
to be replaced.
3. Install the replacement
hard disk(s).
Boot the System
4. Make sure the Release 5
Software Diskette #1 is
write-protected.
5. Insert the Release 5
Software Diskette #1
into the FD.
6. Adjust the baud rate of
the terminal/teleprinter
to 300, 1200, or
9600 baud.
7. Turn ON the power to
the VP 300. With the
teleprinter baud rate
set, press twice.
Enter
VP 300 Description and Response
Refer to the MAINTENANCE chapter in this manual, Hardware
Replacement section.
The following messages are printed:
CPU Model 300-6004-101
. . . .. 05MB . . . . . . . . . . 1200 BAUD MODEM . . . . . .
BOOTING FROM FLOPPY DISK
. . XBOOT . . .
- - - - - - - - SYSTEM SOFTWARE RELEASE L.5.3.1 (MM/DD/YY) - - - - - - - -
DAY MM/DD HH:MM:SS YYYY ID:000 S/N:00000 PBX: 00
(MODEM ENABLED) LAST LOGON: MM/DD HH:MM
@WAITING FOR VCU READY
LOADING VCU WITH FILE F:VCU
VCU STARTED
SYSTEM INITIALIZATION SUSPENDED!
PASSWORD:
@
At this point, the VP 300 has completely booted from floppy.
PROCEDURES
Rev A1
Toshiba VP Systems Release 7.1 July, 1994
6-65