Toshiba VP 300 Installation Instructions Manual page 571

B. Connect the modular adapter to the 25-pair cable associated with slot 1.
C. Connect a Superset 4 phone to the 25-pair cable of the PBX extension used for the first
MIC port.
Only the first four jack positions of the modular adapter are used per cable.
D. Wait for the PBX to initialize the Superset 4. This may take several seconds. Once the
set is initialized, the display should show the time and date. If the display does not
show the time and date within 30 seconds of connecting the phone, correct the problem
before continuing. If the display contains information other than the time and date,
lifting the Superset handset off-hook and replacing it may correct the problem.
E. Go off-hook on the Superset 4 by picking up the handset and check for dial tone. If
dial tone is present, verify that the display is blank, and the LCD line indicator next to
the prime line key is on solid.
➧
NO Determine the cause and correct the problem before continuing.
F. Replace the handset. Does the line indicator turn OFF, and do the time and date return
to the display?
➧
NO Determine the cause and correct the problem before continuing.
G. Check the display for the FWD prompt, located near the left edge of the Superset 4
display. If the prompt is not ON, proceed with step H. If the prompt is ON, the
Superset 4 has some type of forwarding turned ON. Turn the forwarding OFF as
follows:
1. Press the select features button.
2. Press 1 to select the FWD feature.
3. Use softkey 6, NEXT, to cycle through the various types of forwarding. If softkey
2 is labeled OFF for any type of forwarding, press softkey 2 to turn that type of
forwarding OFF.
4. Once all types of forwarding are OFF, press softkey 1, EXIT.
H. Check the display for the NO DIST'B prompt, located near the left edge of the
Superset 4 display. If the prompt is not ON, proceed with step I. If the prompt is on,
the Superset 4 has Do Not Disturb turned ON. Turn if OFF as follows:
1. Press the select features button.
2. Press 2 to select the NO DIST'B feature.
3. When the OFF prompt appears over softkey 2, press softkey 2 to turn Do Not
Disturb OFF.
I. Repeat steps A through H for each of the MIC ports.
MITEL SX-2000 ADAPTIVE INTEGRATION
Toshiba VP Systems Release 6.1
10.3-29
February, 1993