Toshiba VP 300 Installation Instructions Manual page 471

Superset 4 has some type of forwarding turned ON. Turn the forwarding OFF as
follows:
1. Press the select features button.
2. Press 1 to select the FWD feature.
3. When the OFF prompt appears over softkey 2, press softkey 2 to turn forwarding
OFF.
F. Check the display for the NO DIST'B prompt, located near the left edge of the
Superset 4 display. If the prompt is not ON, proceed with step G. If the prompt is ON,
the Superset 4 has Do Not Disturb turned ON. Turn if OFF as follows:
1. Press the select features button.
2. Press 2 to select the NO DIST'B feature.
3. When the OFF prompt appears over softkey 2, press softkey 2 to turn Do Not
Disturb OFF.
G. Repeat steps A through F for each of the MIC ports.
2. SUPERSET LINE EXTENSION NUMBER CHECK
This test verifies that the PBX extension numbers assigned to the MIC ports match
the corresponding extension numbers in the VP 300's SLOTS Table, and also tests
that each MIC Superset extension can perform a screened transfer to another
extension.
A. Label the single line telephone with a message waiting indicator as phone B. Label the
other single line telephone as phone A. The following tests refer to the extension
numbers of these phones as EXT-B and EXT-A, respectively.
B. Connect a Superset 4 to the extension assigned to the first MIC port of the VP 300
used for answering calls. Do not use the MIC extension that is used for Message
Waiting Indication.
C. Connect phone A to extension EXT-A. Connect phone B to extension EXT-B. The
message waiting indicator on phone B must be OFF before proceeding with testing. If
the indicator is flashing, cancel the message waiting condition before continuing.
D. From phone A, dial the extension number of the first MIC port. Does the Superset
ring?
➧
NO Determine the cause and correct the problem before continuing.
E. Answer the call on the Superset, and verify the circuit quality. If the quality is bad,
determine the cause and correct the problem.
F. Press the TRANS/CONF softkey (this should appear as softkey 3) to initiate a transfer.
If the softkey does not appear, the Superset extension may be configured incorrectly in
the PBX configuration. Correct the problem before continuing.
G. Check for stutter or solid dial tone after pressing the softkey. If neither is present,
correct the problem before continuing.
MITEL SX-200 DIGITAL ADAPTIVE INTEGRATION
Toshiba VP Systems
10.1-27
Release 7.1 July, 1994