Vp 300 Configuration Changes For Mwi And Cpi - Toshiba VP 300 Installation Instructions Manual

10.3-52 Installation and Maintenance Manual
I
VP 300 Configuration Changes
Item
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Toshiba VP Systems Release 6.1 February, 1993
Table 10.3-4

VP 300 Configuration Changes for MWI and CPI

Description
Assign COS Attribute 9 only to mailboxes that will use
MWI to activate message waiting lamps or message
waiting dial tone.
For mailboxes assigned COS Attribute 15, set these index
values to be one ring less than the number of rings for
RNA diversion in the Mitel SX-2000.
Assign COS Attribute 15 only to mailboxes of extensions
that will forward to the VP 300 for call coverage.
Assign INFORMATION Table Index 25 to allow mailbox
holders to quickly change their greetings without first
entering their mailboxes.
Assign COS Attribute 58 to non-integrated ports.
Modify System Parameter 13 as follows:
TRANSFER INITIATE CODE = FE
RECONNECT CODE AFTER NO ANSWER = F
RECONNECT CODE AFTER BUSY = F
RECONNECT CODE AFTER FAST BUSY = F
TRANSFER COMPLETE CODE = NONE
Modify System Parameter 16 —
ALTERNATE TRANSFER INITIATE CODE
ALTERNATE RECONNECT CODE AFTER NO ANSWER
ALTERNATE RECONNECT CODE AFTER BUSY
ALTERNATE RECONNECT CODE AFTER FAST BUSY
ALTERNATE TRANSFER COMPLETE CODE
If alternate transfer codes are required, configure them
according to the specific application.
Modify System Parameter 33 to be NONE.
Modify System Parameter 56 to be 0.
Modify System Parameter 77 to be YES.
Modify System Parameter 79 to be the PBX feature
access code for Message Waiting – Activate
Modify System Parameter 80 to be E.
Modify System Parameter 81 to be the PBX feature
access code for Message Waiting – Deactivate.
Modify System Parameter 82 to be E.
Command Complete
.A COS
.M INFO
INDEX 7
INDEX 8
.A COS
.M INFO
.A COS
.M SYS 13
.M SYS 16
.M SYS 33
.M SYS 56
.M SYS 77
.M SYS 79
.M SYS 80
.M SYS 81
.M SYS 82