Toshiba VP 300 Installation Instructions Manual page 397

I Hard Disk Remove for Release 6.1 and Later
This section provides the procedures to follow when removing a drive from a multiple-drive system.
This procedure applies when you intend to remove a disk without immediately replacing it.
When doing the Hard Disk Remove procedures, make sure that the diskettes being used are
for the correct release level.
Action
Remove the Drive(s)
1. Forward ports.
2. Remove the hard disk(s)
from the system.
Boot the System
3. Make sure Software
Diskette #1 (for the
correct release level) is
write-protected.
4. Insert Software Diskette
#1 (for the correct release
level) into the FD.
5. Adjust the baud rate of
the terminal/teleprinter to
300, 1200, or 9600 baud.
6. Press the Reload button
to boot from floppy
diskette. With the
teleprinter baud rate
set, press
Enter
VP 300 Description and Response
Refer to MAINTENANCE, Hard Disk Drive (HD) Replacement, for
Hard Disk Removal procedures. Hard disks may be hot plugged.
The following messages are printed:
twice.
CPU
. . . .. 05MB . . . . . . . . . . 1200 BAUD MODEM . . . . . .
BOOTING FROM FLOPPY DISK
. . XBOOT . . .
- - - - - - - - SYSTEM SOFTWARE RELEASE L.6.0.X (MM/DD/YY) - - - - - - - -
DAY MM/DD HH:MM:SS YYYY ID:000 S/N:00000 PBX: 00
(MODEM ENABLED) LAST LOGON: MM/DD HH:MM
@WAITING FOR VCU READY
LOADING VCU WITH FILE F:VCU
VCU STARTED
SYSTEM INITIALIZATION SUSPENDED!
PASSWORD:
@
PROCEDURES
Model 300-6004-101 Rev A1
Toshiba VP Systems Release 7.1
6-83
July, 1994