Toshiba VP 300 Installation Instructions Manual page 294

5-136 Installation and Maintenance Manual
I Display Filters
Toshiba VP Systems Release 7.1 July, 1994
Seven filters can specifically define the type of information that is displayed in the CDR
log. Multiple filters can be used in a command line, but each filter can appear only once.
However, if only the first letter or two of the transaction type or status value is entered, all
transaction types or status values beginning with the letter(s) entered are filtered. If no
filter is specified, all information is displayed.
Transaction Type Transaction type filter. Enter the transaction type that should
XA <XACTIN>
be displayed. In the command string, type XA [ type ] . For
example, enter XA NTMSGD for network messages send day, or
XA NT for all network transactions.
Status
Status filter. Enter the type of status information that should
ST <STAT> be displayed. In the command string, type ST [ status ] . For
example, enter ST FLLQ for failed line quality test or ST FL for
all network failure conditions.
Port Port filter. If a specific port should be displayed, enter that port
PR <PRT>
number in the command string. The designation of a single port
number must consist of three digits (e.g., 005 for Port 5).
For ports above 9, the two-digit port number should be preceded
by a single 0 (e.g., 023). For ports above 9, a range of ten ports
can be specified by entering the 0 plus one significant number for
the beginning of the range. For example, enter PR 03 to display
ports 30 thru 39.
COS
COS filter. The COS of the incoming port/trunk group for an
CO <COS> integrated call record can be displayed. The designation of a
single COS must consist of three digits. For COS 1 thru 9, the
COS should be preceded by 00 (e.g., 001). For COS 10 thru 99,
the COS should be preceded by 0 (e.g., 037). For COS 10 thru 99,
a range of ten COS can be specified by entering the 0 plus one
significant number for the beginning of the range. For example,
enter CO 09 to display COS 90 thru 99. To display COS 100 to
199, enter 1.
Mailbox Mailbox filter. Specific or partially specified mailbox number
MA <MBX>
prefixes can be displayed. For example, to display all mailboxes
that start with 43, enter MA 43.
Messages Sent Number of messages sent filter. With this filter, the number of
MS <MS>
messages sent during a transaction can be defined. For example,
if abandon calls for a specific transaction type should be
displayed, specify MS 00. All calls with 0 messages left would be
displayed.
Messages Erased Number of messages erased filter.
ME <ME>