Toshiba VP 300 Installation Instructions Manual page 466

10.1-22 Installation and Maintenance Manual
System Parameter 16— ALTERNATE TRANSFER INITIATE CODE
ALTERNATE RECONNECT CODE AFTER NO ANSWER
ALTERNATE RECONNECT CODE AFTER BUSY
ALTERNATE RECONNECT CODE AFTER FAST BUSY
ALTERNATE TRANSFER COMPLETE CODE
Modify the value of Alternate Transfer Initiate Code to be FE. Modify the
value of all Alternate Reconnect Codes to be F, and modify the value of
Alternate Transfer Complete Code to be NONE.
System Parameter 33 — PBX INITIALIZE CODE
Modify the value of System Parameter 33 to be NONE.
System Parameter 56 — NUMBER OF TRANSFER RETRIES IF
FLASH FAILS
This system parameter must be set to 0 for all systems using Mitel
Integration Cards.
System Parameter 77 — PBX SUPPLIES MOMENTARY
DISCONNECT
Modify the value of System Parameter 77 to be YES. Although the Mitel
SX-200 Digital does not actually provide momentary disconnect, the MIC
simulates the momentary disconnect to the VP 300 when it detects that a
caller has hung up.
System Parameter 79 — LAMP MW: "ON" PRE-EXTENSION
DIGITS
System Parameter 81 — LAMP MW: "OFF" PRE-EXTENSION
DIGITS
If the VP System is using COV Voice Mail port message waiting
indication, modify both System Parameter 79 and System Parameter 81 to
be 00. These parameter values tell the integration software to perform
message waiting indication using the COV Voice Mail feature instead of
the sub-attendant feature. If the VP System is using sub-attendant
message waiting indication, modify System Parameter 79 and System
Parameter 81 to be NONE.
System Parameter 85 — RECONNECT CODE AFTER 3RD PARTY
HUNG UP
Modify the value of System Parameter 85 to be F.
System Parameter 116 — INTEGRATION TYPE
Modify the value of System Parameter 116 to be YES.
System Parameter 117 — RINGBACKS BEFORE ANSWERING AX
PORT
Modify the value of System Parameter 117 to be 5. This gives the VP 300
extra time to receive the displays from the PBX.
Toshiba VP Systems Release 7.1 July, 1994