Integration Card Replacement (Release 6.1 And Later) - Toshiba VP 300 Installation Instructions Manual

5-82 Installation and Maintenance Manual
Installing Line
Interface Cards
I Integration Card Replacement (Release 6.1 and later)
The VP 300 integration cards installed in Shelf A are designed to be hot plugged; that is, the system
does not need to be powered down to remove or install the cards.
No more than one integration card at a time may be removed or installed with the power
ON.
Removing Line
Cards
Toshiba VP Systems Release 7.1 July, 1994
Installation of the PCA is as follows:
1. Put on antistatic wrist strap. Connect it to an unpainted portion of the
cabinet.
2. While holding top and bottom edges, slide the LIC into the card cage.
3. Pivot the card ejectors as needed to grip small flanges on the front edges of
the card cage.
4. Firmly seat the LIC connectors into the Motherboard by pressing ejectors
against the front edge of the LIC. The ejectors will clip onto small pins on
the LIC when the connectors have seated.
N WARNING N
Do not slam the LIC into the cabinet, as this may damage the board
or the motherboard connectors.
5. Initialize ports by entering:
TE C 2 x y
where x is the first port in the card, and y is the last port in the
card.
6. Test system for proper operation.
7. Close and lock the door to the cabinet.
N WARNING N
The procedure to replace a Line Integration Card is as follows:
1. Unlock and open the door of the cabinet.
2. Put on antistatic wrist strap. Connect it to the unpainted portion of the
cabinet.
3. Take integration card out of service by entering at the @ prompt:
CDINTG x y (x = slot number; y = unit number)