Toshiba VP 300 Installation Instructions Manual page 373

Action
Choose the Correct
Disk Option
14. Insert Diskette #1 (for the
correct release level) into
the FD.
15. @DSKTST
Enter
16. @DISKO
Enter
17. Choose option 4 —
RESTORE SYSTEM.
18. Enter the number of
drives in your system.
VP 300 Description and Response
At the @ prompt enter the slot number for the restored drive. The
VCU tests the slot and updates its status record.
The following menu is presented:
CURRENT STATUS
Slot Type ID Status
- - - - - - - - - - - - - - - - - - - - - - - - - - - - -
B3 System1 S1 UNKNOWN
B4 System2 S2 UNKNOWN
C1 Voice1 – – EMPTY
C2 Voice2 – – EMPTY
C3 Voice3 – – EMPTY
C4 Voice4 – – EMPTY
DISK OPTIONS
1. ADD DISK
2. REMOVE DISK
3. REPLACE A DISK
4. RESTORE SYSTEM
5. UPGRADE LANGUAGES
Select option to be performed
(1–5, – Empty line = EXIT)
:
5. UPGRADE LANGUAGES is shown for systems at Release
7.1 or later.
The following is then presented.
:4
Enter number of drives
(1 – 6, Empty line = EXIT)
:
Release 6.1, the VP 300 displays the following. (There may be
a delay before this screen appears.)
RESTORE IS COMPLETE.
REFER TO HARD DISK PROCEDURES (RESTORE).
Release 7.1, the VP 300 displays
:
Purchased Quantity of Languages: 2
Current Allocated Quantity: 0
Enter Quantity of languages Desired (1-2, Empty Line = 1):
Allocation quantity selected = 1
ARE YOU SURE? (Y/N, empty line = N): Y
Proceeding with Restore...
DONE
@
PROCEDURES
Configured
Configured
Configured
Not Configured
Not Configured
Not Configured
Not Configured
Toshiba VP Systems Release 7.1 July, 1994
6-59